Motorola DR 3000 - Manual (Page 12)

Chapter 2 Mechanical Installation
This section describes the procedures to unpack and mechanically install the MOTOTRBO
Repeater. A variety of mounting methods are possible, depending on which type of cabinet or rack
(if any) has been selected to house the repeater(s). Installation procedures are provided for each of
the cabinet and rack types.
2.1 Unpacking Equipment
2.2 Transferring Equipment from Shipping Container to Rack or
Cabinet
The repeater is shipped in a box. Upon delivery, the equipment must be removed from the container
and transferred to a rack or cabinet.
NOTE: Customer-supplied cabinets and racks must have mounting rail and hole spacing compatible
with EIA Universal 48.3 cm (19 inches) specifications. Cabinets must provide adequate
ventilation (as detailed on page 3) and must meet the following criteria:
- 41.3 cm (16.25 inches) deep
- 48.3 cm (19 inches) wide
- 13.4 cm (5.25 inches) high
Two mounting rails 5 cm (2 inches) from front cabinet with front mounting holes 5.7 cm (2.25 inches)
apart (center to center).
Contact Motorola Technical Support for specific question regarding mounting equipment in
customer-supplied cabinets.
Be sure to observe proper electrostatic discharge precautions if modules must
be removed from the repeater.
Inspect the equipment for damage immediately after unpacking,
and make a report of the extent of any damage to the
transportation company and to Motorola.
!
C a u t i o n
!
W A R N I N G
!