Standard Horizon HX-471S - Manual (Page 22)

HX471S Page 20
[
p(UP)] KEY
Press to select a desired channel. Each press increases the channel
number. When held down, the channels increase continuously.
[
q(DOWN)] KEY
Press to select a desired channel. Each press decreases the channel
number. When held down, the channels decrease continuously.
NMEA TERMINAL
Connect to GPS receiver that outputs NMEA sentences GLL, GGA, GNS,
and RMC via the CD-25 Charger Cradle. Keep these terminals clean.
[SCAN] KEY
Starts scanning and priority scanning of programmed channels. When
scanning, press and hold this key to turn on and off priority scan (P is
shown on the left side of the display during Priority scanning).
[PRESET] KEY
Immediately recalls one of up to 10 user preset memories for each band
(shown as P0-P9 on the LCD). Pressing this key repeatedly scrolls
through the preset memory channels.
[H/L] KEY
On the Marine Band, changes the transmitter output power between High
(5 Watts), Medium (2.5 Watts), and Low (1 Watt). Does not operate on
“Low power only,” Marine “transmission inhibit,” or FRS channels.
[DW] KEY
Automatically scans between the priority channel and another selected
channel (including FRS or a MURS channel). When receiving a signal
on the selected channel the radio will dual watch to the priority channel.
[MENU] KEY
Select the Marine Band then press to select the Setup mode. This mode
allows features and functions to be changed.
Refer to section 13. MENU (“SET”) MODE for additional information.