Kussmaul Electronics 091-9B-1 - Manual (Page 5)

VEHICLE WIRING INSTALLATION
1. The Auto Pump is supplied with a 120 volt A.C. line cord and is ready to operate. The line
cord may be plugged into an available outlet or the cord may be cut and permanently wired to
the 120 volt A.C. system in the vehicle.
2. The compressor is calibrated to cut-in at 70 PSI and cut-out at 90 PSI . For higher cut-in
and cut-out, turn the range nut clockwise . To lower cut-in turn range nut counterclockwise .
Do not exceed 100 PSI .
COMPRESSOR OUTPUT IS 100 PSI MAXIMUM. DO
NOT EXCEED 100 PSI OR YOU WILL VOID
WARRANTY.
NOTE
THIS PUMP REQUIRES A MINAMUM OF 110 VOLTS
FOR OPERATIONAT LOWER VOLTAGES THE
PUMPWILL NOT START