La Crosse Technology WS-9257U-IT User Manual
Page 4
4
within 80 seconds, remove the batteries from both units for 2 minutes and start
again from step 1.
4.
Allow the weather station and the transmitter to remain 5-10 feet apart for 15
minutes after set up to establish a strong connection.
5.
To ensure sufficient 915 MHz transmission after set up, the distance between the
transmitter mounted outside and the weather station inside should not exceed 330
feet (100 meters) distance (open air, no obstructions).
6.
Test the weather station and the transmitter in the positions they will be located for one
hour before permanently mounting. If the outdoor temperature signal goes to dashes restart
from step 1 and try a new location.
HOW TO INSTALL AND REPLACE BATTERIES IN THE THERMO-HYGRO
TRANSMITTER
The outdoor thermo-hygro transmitter uses 2 x AAA, IEC LR3, 1.5V batteries. To
install and replace the batteries, please follow the steps below:
1.
Remove the cover.
2.
Insert batteries, observing the correct polarity (see marking).
3.
Replace the battery cover on the unit.