Lacava W1001H1 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
1. Attach the flexible supply lines and mounting screw to the mixer body.
2. Insert mixer body with one rubber washer through the hole in the mounting surface.
3. From underneath the mounting surface install one foam washer, the steel washer, and the extension around the
mixer body.
4. Slide half moon washer onto the mounting screw and thread brass nut on (WARNING: Overtightening may damage
mounting surface)
Replacing Ceramic Mixing Cartridge
1. Close the inlet piping.
2. Remove the escutcheon ring (1), rubber washer (2), and plastic ring (3).
3. Pull off the control lever (4) and unscrew the brass ring (5) with the provided key.
4. Remove the cartridge (6) from it’s housing and replace with the new cartridge (part: RCMB058).
5. Reassemble by reversing steps 2 and 3.
6. Open inlet piping and check for leaks.