LD Systems LDMON 81AG² - Manual (Page 8)

8
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
3
5
6
2
1 4
7
REAR PANEL LDMON81AG2:
1 POWER SOCKET WITH FUSE HOLDER
Always make certain that the operating voltage of the powered monitor (printed on the rear panel) matches
the mains voltage in your region An appropriate mains cord is included in the package.
IMPORTANT INFORMATION: Always replace the fuse only with a fuse of the same type with the same rating
(printed on the rear panel of the power amplifier). If the fuse blows repeatedly, please contact an authorized
service centre.
2 ILLUMINATED POWER SWITCH
Lights up when the monitor is switched on and properly connected to the power mains.
Before switching the powered monitor on or off, always adjust the volume to zero (turn the knob all the way
to the left).
3 INPUT - BALANCED XLR / 6.3 MM JACK INPUT (COMBO)
The XLR input socket is used to connection to a mixing board or another signal source.
4 DIRECT OUT - BALANCED XLR OUTPUT
Used to loop through the signal from the line input.