Legrand AL2000 Small Aluminum Surface Raceway - Manual (Page 2)

AL2003 MOUNTING CLIP AL2006 COVER CLIP
To close any gaps. That accur from field cutting, snap
AL2006 Cover Clip over joints, where two adjoining
pieces come together. Use for external support of raceway. To install attach
AL2003 to mounting surface with screws. Snap
raceway base into AL2003.
AL2000 SYSTEM PRODUCT APPLICATIONS
INSTALLATION:
1. Supply conductors may be fed from 1/2" trade size KO in base, or though Feed End Fitting (AL2010A). This system is designed
with capacity for additional feed or circuitry conductors.
2. Attach base section on mounting surface with AL2003 Spring Mounting Clips, or by drilling 9/32" holes in the base and use #8
set crews.
3. Use Ground Adapter (AL2009) provided to secure ground connection. To relocate, loosen set screw and twist counter
clockwise. Position in between receptacles (to avoid interference) and assemble in reverse order.
4. Connect circuit wires with connectors.
5. Additional multiple outlet sections or AL2000 raceway section may be attached at end with AL2001 coupler.
6. Close ends with blank end fitting (AL2010B) or (AL2010A).
7. Snap in cover section.
8. In-Line receptacle AL2043.
9. Snap in cover clip to cover joint where lengths of cover or base come together.
10.To remover cover, insert removal tool into groove, push down and twist.
Note: All mounting methods must result in flush interior surface. Consult factory
for special outlet assemblies manufactured to your specification.
1
6
4
7
10
9
8
5
3
2