Legrand AL2040A Aluminum Surface Raceway User Manual
Page 4
AL2411 90° FLAT ELBOW
AL2417 INTERNAL ELBOW
AL2415 TEE ELBOW
AL2418 EXTERNAL ELBOW
AL2400WC WIRE CLIP
At 90° turn on same surface, position AL2411 Flat Elbow at
end of AL2400 base. Position next bases section onto other
end of AL2499B.Center couplings over base joints and
tighten screws. Install fitting cover after wiring.
Install AL2400 to raceway base BEFORE mounting raceway
base. Fasten base section to surface joints,tighten setscrews.
Center couplings over base joints and tighten screws.
Install fitting cover after wiring.
AL2415 tee fitting, position fitting at end of AL2400 base.
Install other base section to other end of fitting. Center
couplings on joints and tighten screws. Install fitting
cover after wiring.
At 90° outside corner, position AL2418 external elbow at end
of joints and tighten screws. Install fitting cover after wiring.
For retaining wires in long raceway run, Snap-in AL2400WC
Wire Clip approx. 30" apart into AL2400 base.
The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251
INST007 R1 – Updated October 2003 – For latest specs visit www.wiremold.com
© Copyright 2003 The Wiremold Company All Rights Reserved
AL2416 CROSS ELBOW
AL2416 cross Elbow, position fitting at end of AL2400B base.
Install other base sections to other ends of the fitting. Center
Couplings on joints and tighten screws. Install cover fitting
after wiring.