Legrand 881AMD8TC - Manual (Page 5)

5
7. Align gasket over receptacle and press bead into flange
channel. Reattach slide cover with two #6 screws.
CAUTION: Gasket must be set in place to provide scrub
water seal.
CAUTION: Receptacle supplied with this activation is not
suitable for direct field wiring. Contact manufacturer
for replacement. Field modifications will void UL
Listing. Replacement receptacle is limited to this
manufacturer's catalog No. RC4REC2.
NOTE: For Isolated ground applications, apply IG icon on
receptacle slide as shown.
3. Orient the open side of the adapter with
the divided side of the box and push
into place – No glue required!
4. Remove the slide cover, gasket, and
trim flange to access the
communications compartments.
5. Pull communication cables through
cover. Route cable around the
receptacle shell for devices opposite
the communications compartment.
6. Wire and snap communication jacks
into flange.
897CTC COVER INSTALLATION:
1. Cut a 6 1/2" [165mm] circular
concentric opening in the floor
covering.
2. Connect receptacle leads to circuit
conductors with twist-on wire
connectors or other approved
methods.
WARNING:
Receptacle mounting
means not grounded.
Grounding wire
connection required.
For isolated ground
wiring, connect
ground leads to a
separate isolated
grounding conductor
(see NEC 250-146(d)).
7. Align gasket over receptacle and
press bead into flange channel.
8. Re-attach cover with (2) #6 screws.
CAUTION: Gasket must be set in
place to provide scrub
water seal.
CAUTION: Receptacle supplied with this activation
is not suitable for direct field wiring.
Contact manufacturer for replacement.
Field modifications will void UL Listing.
Replacement receptacle is limited to
this manufacturer’s catalog No.
RC37REC.
NOTE: For Isolated ground applications, apply
IG icon on receptacle slide as shown.