Legrand 861 Series Outlet Boxes for Wood - Manual (Page 3)

3
Point Keystone Tab
Away From Bezel.
TracJack Blank
(supplied)
Foam Plug
(supplied)
TracJack
(sold separately)
Ortronics Series II Bezel and
Communication Jack (Series II
Bezel Included; Series II Modular
Inserts sold separately)
Communication Jack
(sold separately)
Ortronics TracJack Bezel and
Communication Jack (TracJack
Modular Inserts sold separately)
Point Keystone Tab
Away From Bezel.
Lower Level Bezel
Installation (Typical for
Fiber Installations) (Fiber
Jack sold separately)
Pass & Seymour ACTIVATE
Bezel and Communication Jack
3. Wire communication jacks and snap into adapter bezel.
2. Wire and snap appropriate
communication jacks in adapters as
shown below. Insert blanking plugs
or neoprene foam blocks in unused
communication ports.
1. Attach trim flange with jacks to the
outlet box using (4) #6 X 3/8" flat
head screws.
COMMUNICATIONS COVER INSTALLATION: Cat No. 861AMDTC & 861AMDRTTC
5. Install slide cover with (2) #6 cover screws. Do not over tighten
screws. Complete the installation by pushing the box into the
hole until firmly seated against the floor finish.
4. Align gasket over devices and press bead into flange.
CAUTION: Gasket must be set in place to
provide scrub water seal.
CAUTION: Do not operate tile
stripper or resurfacing
equipment over top of
cover. This may result
in damage to the finish
of the product.
Gasket
Slide Cover