Legrand RC3 Receptacle Replacement - Manual (Page 4)

4
Step 5 Pull receptacles and receptacle brackets
out of poke-thru.
Step 6 Guide replacement receptacle brackets into place.
Direct wire leads through indicated opening to
junction box below.
Wire Path to
Junction Box
NOTE: Be certain to line up the trim ring with
the holes on the receptacle bracket.
The trim ring only attaches one way.
Screws Provided
IMPORTANT: Receptacle bracket slides into the
tabs shown here.
CAUTION: Gasket must be set in place to
provide scrub water seal.
Step 7 Attach trim ring to bracket with four screws provided.
Attach trim ring to receptacle bracket with two
screws provided.
Step 8 Place gasket support on receptacle bracket. Place
internal gasket on gasket support and press around
edge to seat the gasket into
the groove in the trim ring.
Cat. No. RC4REC2
or RC4REC2-25