Legrand Source 1 437 - Manual (Page 2)

Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1B0001 R1 0207 © Copyright 2007 Wiremold / Legrand All Rights Reserved
1. Pull wires through the hole in the bottom of the
attaching ring. The adjusting ring should then
be installed at the desired height.
2. Wire device and attach to the adjusting ring
(see Figure A).
3. After the gasket is put in place, the flange is
attached to the adjusting ring (see Figure B).
4. For power: The flip lid cover plate can be
attached to the flange (see Figure B).
5. For data: Turn slides upside down with thin
edge to inside. Attach cover plate to flange
(see Figure C).
FLUSH ACTIVATION:
1. Pull wires through the hole in the bottom of the
attaching ring.
2. Wire device and attach to threaded bosses in
bottom of attaching ring. Fasten receptacle
cover plate to device (see Figure A).
3. Install adjusting ring at desired height (see
Figure B).
4. Cover plate can be locked in place with quarter
turn swivel (see Figure C).
RECESSED ACTIVATION (S126R):
Walkerduct
Figure A
Figure C
Figure B
Wiring Device
437 Attaching Ring
Adjusting Ring
897AR for Power
(Shown) 898AR
for Tele/Data
Power Cover
Plate – S125B
Neoprene Gasket
Adjusting Ring
Assembly
Carpet Plate
S124B (Shown) or
S124BLK/BRN
Tele/Data Cover Plate
NOTE: Minimum 2 3/8" [60mm] Attaching
Ring required.
Walkerduct
Figure A
Figure C
Figure B
Cover Plate
Closure Plate
Wiring Device
Attaching Ring
437
Adjusting Ring
Swivel Lock
Adjusting Ring
Reversible Slides
Cover Plate