Legrand ALDS4000 Designer Series Large Raceway - Manual (Page 3)

3
Snap Activation Plate onto Raceway Base.
Squeeze
First
Installation complete. (DS4047R shown.)
Install Device Plate first. Insert and tighten Screw then snap
in desired Adapter Bezel.
FORWARD FACING ACTIVATIONS
DS4047MAB – No Bracket required
Insert & tighten Screw.
DOWNWARD FACING ACTIVATIONS
Snap on Cover and secure with Screw to complete installation.
Secure Cover in place with Screw.
Step 2.
Installation Complete.
DS4006 Seam Clip
Step 1.
The DS4006 Seam Clip is used to cover the cut edge of a
cover section. Make sure any gaps between raceway Covers
are less than 1/16" [1.5mm].