Legrand Uniduct 2700 Series Low-Voltage Latching Raceway - Manual (Page 2)

Blank End Fitting:
2710B/2810B/2910B
To cover the open
end of the Uniduct:
Snap the blank end
fitting (2710B/2810B/
2910B) onto the open
end of (2700/2800/
2900) Uniduct.
Drop Ceiling Connector:
2786/2886/2986
For bringing cables from
ceiling to raceway: Cut a hole
in the ceiling tile right next to
the metal grid. Drop the cables
from the ceiling into the Uniduct.
Push the drop ceiling connector
(2786/2886/2986) through the
hole so that the notch in the
large end of the connector butts
with the metal grid. Snap the
drop ceiling connector
(2786/2886/2986) onto the
Uniduct (2700/2800/2900).
Reducing Connector:
2889/2989/2989A
To go from larger to smaller Uniduct:
Install the Uniduct (2700/2800/2900)
butted as shown. Snap the reducing
connector (2889/2989/2989A) onto
the Uniduct leaving no gap. Snap
cover clip (2706/2806/2906) over
connection. When reducing from a
fitting to raceway, cover clip is
not required.
TYPICAL PROCEDURE FOR INSTALLING
DEVICE BOXES
1. Remove proper tongue on the device box (NM2048)
base. (See Figure 1.)
2. Notch proper knockout in cover using knife. (See
Figure 2.) Use pliers to remove knockout inward
for cleaner edge.
(Trimming may be necessary.)
3. Fasten device box base to wall using screws
(not provided).
4. Snap device box cover onto the base.
5. Mount device box and faceplate.
2800
2900
Cover Side View
Cover
Front View
Base Front View
2700 Tongues
Figure 1
Figure 2
NM2048 Cover
NM2048 Base
2700/2800/2900
Uniduct
Faceplate
Figure 3
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
40307R2 – Updated July 2005 – For latest specs visit www.wiremold.com © Copyright 2005 Wiremold / Legrand All Rights Reserved