Legrand AU1004-XX - Manual (Page 2)

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 2 of 2
INSTRUCTION/INSTALLATION SHEET
FLUSHMOUNT SINGLE SOURCE
INPUT
IS-0392 REV. O
©Copyright 2007 by On-Q/Legrand All Rights Reserved .
C. Pull the Category 5 cable out through the low voltage bracket
and plug it into the RJ45 Cat 5e jack on the rear of the Flush
Mount Single Source Input (see Figure 2). Then mount the Flush
Mount Single Source Input into the low voltage bracket and
cover with a wall plate. There is a jumper on the rear to select
Knob or Keypad only volume control use.
D. Connect a pair of RCA interconnect cables from the receiver/pre-
amplifier line level output (2nd zone out, tape 1 out, tape 2 out,
etc.) to the AUDIO IN jacks of the Flush Mount Single Source
Input (see Figure 3). It is recommended that you NOT use a pre-
amp (or non fixed output) from a receiver/pre-amplifier. If this is
used the output will be post the receiver/pre-amplifier volume
control thus making the output to the Flush Mount Single Source
Input vary with the volume setting of the receiver/pre-amplifier. If
a FIXED output like tape 1 or tape 2 is used, it is independent of
the volume setting of the receiver/pre-amplifier thus allowing the
lyriQ™ Volume Controls to have full control over the sound level.
NOTE: If the TAPE OUTPUT jack is used and must be shared with a Tape Deck, then audio Y cables
can be used.
E. If IR control is being used plug the emitters into the IR EMITTER outputs and place them onto the IR receiver
windows of the source equipment via the peel away adhesive strip.
F. If the Universal IR
Target, PN F7426, is
being used, plug it into
the IR INPUT jack on
the Flush Mount Single
Source Input.
G. Check all other system
components and then
apply power to the
lyriQ™ Audio
Distribution Module in
the Enclosure.
H. The Green LED on the
front of the Flush Mount
Single Source Input
lights to indicate an
active audio source.
The Red LED indicates
any IR activity.
Figure 2
RJ45 jack
Knob/Keypad
Jumper
Figure 3