Legrand HA5202 - Manual (Page 2)

INSTRUCTION / INSTALLATION SHEET
TVDI Expander for Unity Integration
Module (P/N HA5202)
IS-0457 Rev. O
301Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2009 by Legrand All Rights Reserved. Page 2 of 2
3. Connect a Category 5 jumper from the “Control Interface In” RJ-45 jack on the first HA5202 to an
LCD/TVDI RJ45 jack on the Unity Integration Module (HA6001).
4. If being cascaded, connect a Category 5 jumper from the “Interface Cascade Out” RJ45 jack on
the first HA5202 to the “Control Interface In” RJ45 jack on the cascaded HA5202.
5. For any cascaded HA5202 modules, plug the 24VDC power supply cable into the power jack on the
HA5202 module/s and plug the power supply/s into an AC outlet.
NOTE: All AC powered devices in a Unity system should be powered up at the same time (i.e. use
a common power strip for the individual AC adapters).
6. Verify system functionality.
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.
Figure 2
Figure 2