Legrand DA1008 - Manual (Page 2)

INSTRUCTION / INSTALLATION SHEET
8-Port Gigabit Switch (DA1008)
IS-0396 Rev. B
301Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.legrand.us
©Copyright 2014 by Legrand All Rights Reserved. Page 2 of 6
4. COMPLIANCE
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio or TV communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the DA1008 off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
A. Reorient or relocate the affected receiving radio or TV antenna.
B. Increase the separation between the Switch and affected device.
C. Connect the Switch into an outlet on a circuit different from that to which the affected equipment is
connected.
D. Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
All trademarks and brand names are the property of their respective proprietors.
Specifications are subject to change without prior notification.
Figure 2
DA1008 used for
Router/Switch
port expansion
Router/Switch
To Network