Lencore Spectra Tangent Speaker - Manual

Spectra Tangent® Speaker Installation Instructions:
1. Refer to the sound masking layout (drawing) provided to locate the appropriate speaker installation position.
2. Cut a 4.5” hole in the drywall or acoustical ceiling tile
3. Install the Cat 5e cable with standard RJ45 connector into the speaker
4. While lifting both torsion springs into a vertical position, slide the speaker into the hole until the grill is flush with
the drywall or acoustical ceiling tile; the torsion springs should hold the speaker firmly in place
The information contained herein is proprietary to Lencore Acoustics Corp. and copyright protected. No part of this document can be
copied, used, or distributed without prior authorization from Lencore. Copyright 201
4. Lencore, Spectra, Spectra i.Net, are trademarks
of Lencore Acoustics C orp. www.Lencore.com
Spectra Tangent® Speaker Wiring Instructions:
1. For first speaker connection to OP: Connect the audio cable– 8 conductor CAT5 from OP channel (either A, B, C,
or D) to INPUT of speaker.
2. For speaker to speaker connection: Connect audio cable– 8 conductor from OUTPUT of previous speaker to
INPUT of next. Follow the same series connections to add up to 8 speakers per channel. The last speaker in any
channel will have only one cable going to its INPUT only. There will be no cable connected to the output.
SPECTRA TANGENT ® SPEAKER
INSTALLATION INSTRUCTIONS
Top
Bottom
Side
Note: If a tile bridge is being installed. After hole is cut in the tile, lay tile bridge across the tile grid. Push the torsion springs back
on speaker and put speaker through both ceiling tile and tile bridge before releasing springs to hold speaker in place in tile bridge.