Louroe Electronics TLM-CS - Manual (Page 2)

MICROPHONE AND SPEAKER CONNECTIONS
Using West Penn 356 as an example cable (see connection diagram, page 3) connect cable as
follows:
If using wiring from other manufacturers, color code may vary
MICROPHONE CONNECTION
1) Connect RED wire to terminal block marked “A” (+12Vdc)
2) Connect BLACK wire to terminal block marked “B” (Audio Output)
3) Connect DRAIN wire (bare) to terminal blocked marked “C “ (Ground)
SPEAKER CONNECTION
1) Using a wire nut, connect GREEN wire (positive) to GREEN wire connected to speaker
transformer
2) Again using a wire nut, connect WHITE wire (negative) to WHITE wire connected to speaker
transformer.
TLM CONNECTION TO LOUROE AUDIO BASE STATION
Most Louroe base stations contain terminal blocks on the rear panel and are the same or similar to
the TLM-CS. Carefully match pins A to A, B to B, etc. Refer to the base station instructions that
accompany TLM instructions.
Page 2 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
INSTALLATION AND OPERATING INSTRUCTIONS
tlm_cs_inst_3/15
MR-4 Mounting Ring
Weight
Shipping Weight
7 5/8” Dia x 2 3/4”D
7 3/8 ”Dia x 3” H
1 lb 8 oz
4 lbs
SPECIFICATIONS (Speaker)
Power rating
Input
Frequency response
Voice coil impedance
7W
70.7V constant
30 Hz to 20 kHz
8
Speaker size 4”
BR-4 Grill with speaker and mic
Sensitivity -45 dBV/Pa
1 Pa = 94 dB SPL
Frequency Response 50 Hz to 15 kHz
Output Line Level (0 dBV, 600 W @ 1kHz)
Current Drain 10mA
Supply Voltage 12 Vdc
SPECIFICATIONS (MICROPHONE)