Louroe Electronics MS-1 - Manual (Page 5)

TESTING AND OPERATION OF SYSTEM
Make sure the Microphone is active. Top part of MS-1 switch must be pressed IN and the Red Rocker
Switch illuminated.
1. Create some sound (radio, someone speaking, etc) near the microphone. The sounds will
transmit to the APR-1’s built-in speaker[9] (see page 6). Adjust the volume of audio by
rotating the volume knob clockwise to increase, or counterclockwise to decrease.
2. To mute the system, press the lower part of the rocker switch IN. The lighted switch will go
dark, indicating power if OFF and the microphone is DISABLED.
3. Again create some sound. There should be no transmission of audio through the base
station (APR-1, etc).
4. If the microphone is directly connected to a recorder, turn ON the recorder to record the
audio from the microphone
RECORDING AUDIO AND AUDIO PLAYBACK
If live audio is to be recorded, connect an RCA patch cable to “Audio Out” of Louroe™ Base
Station[12] (see page 7) or audio interface adapter to “Audio In” of the recording device (DVR, VCR,
etc.)
AUDIO PLAYBACK
For receiving audio playback through the APR-1 Base Station, connect an RCA cable from “Audio
Out” of the DVR, VCR, etc. to “Audio In” [11] (see page 7) of the APR-1. Press the “Audio Playback”
Switch of the recording device, then press “Push for Playback” Switch [7] of the
APR-1 Base Station. Audio playback will be channeled through the APR-1 Speaker [9]
SPECIFICATIONS OF MS-1 MUTE SWITCH
Supply Voltage
Switch contact
Dimensions
Faceplate
12Vdc
9A @125Vac
Weight
Shipping Weight
2.5 oz
1 lb
2 ¾ W x " 4 ½" H
303 Stainless Steel
Backbox Single gang electrical
box (not included)
INSTALLATION AND OPERATING INSTRUCTIONS
Page 5 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
ms_1_inst_3/15