Marantz PM-14S1 - Manual (Page 25)

17
Preparation
Connections
Settings
Tips
Appendix
ENGLISH
Playback
Adjusting the left and right channel
balance
The volume level of the left and right channels can be trimmed
in 0.5 dB steps across a 0.0 – 9.0 dB range.
The factory default setting is 0.0 dB (maximum).
1 Press MENU.
The unit enters the level adjustment mode.
• The left channel level value flashes.
2 Use df to adjust the left channel level.
3 Press 1 .
The adjustment mode selects the right channel.
• The light channel level value flashes.
4 Use df to adjust the right channel level.
5 Press MENU.
The unit exits the adjustment mode.
• If you have connected a “SLAVE” device using the F.C.B.S.
connection (vpage 10), proceed to the slave setting.
Adjusting the tone
1 Press TONE.
The TONE indicator lights, and the mode switches to
the tone adjustment mode.
2 Turn BASS and TREBLE to adjust the tone.
Press TONE again to switch the tone adjustment mode off.
The TONE indicator turns off.
Turning off the sound temporarily
Press ATT.
“ATT” appears on the display and the sound is muted.
• To restore the sound, press the button again.
To restore the sound, press the button again.
Setting the attenuation level when sound is
muted
The attenuation level can be set at –20 dB, –40 dB, or –∞.
• The factory default setting is –20 dB.
1 Press and hold ATT on the unit for 2 seconds
or longer.
The attenuation level will appear on the display.
2 Press ATT on the unit.
The attenuation level setting value changes each time
the button is pressed.
If not operated for 2 seconds, the current setting is saved and
the display returns to normal.
1.PM14S1N_ENG_Final_0708.indd 17 2013/07/11 19:14:18