Marantz SR5200N - Manual (Page 23)

17
ENGLISH
ON SCREEN DISPLAY INFOMATION
The on-screen display, which can be activated by the Main unit or
remote, appears on the TV screen to show the current setting status of
the SR5200.
Note:
Each video input function is set PAL or NTSC for TV format of
OSD.
If this setup does not meet the video input signal, character of OSD
can not synchronize.
So You can select these format function by function.
Press OSD button ¤2 on the remote controller for 3 seconds or
more. "PAL" or "NTSC" will be shown on the display of SR5200,
press OSD button ¤2 again to change the TV format.
The indication on FL display will change " PAL"
→ " NTSC" →
"PAL" →.
This setup is memorized with each video input function.
1. GENERAL INFORMATION
When the OSD button ¤2 is pressed, the current setting are displayed
on the TV monitor.
This display disappears automatically in about 5 seconds after the
button is pressed.
q VIDEO SOURCE:
Displays the current video source being selected with the function selector
TV, DVD, VCR1, DSS or AUX.
w AUDIO SOURCE:
Displays the current audio source being selected with the function selector
FM, AM (MW, LW), CD, TAPE, CD-R, TV, DVD, VCR1, DSS or AUX.
e DIGITAL INPUT:
Displays the digital input that you are using
DIG-1, DIG-2, DIG-3 or DIG-4.
r SURROUND MODE:
Displays the current surround mode
AUTO, STEREO, 6CH STEREO, VIRTUAL, MATRIX, STADIUM,
HALL, MOVIE, 6.1 CH SURR, PLO LOGIC, PLII MUSIC,
PLII MOVIE, DTS
t MASTER VOLUME
Displays the current volume level.
The volume level is higher at the right of the display.
Note:
The On-Screen Display signals can be output from the TV MONI
composite video (RCA) output and the TV MONI, S-Video output
jacks.
With some video equipment or software, the On-Screen Display
characters may be distorted due to noise or tracking adjustment
error.
2. FUCTION SELECT & SURROUND MODE
When a function selector button or surround mode button is pressed
VIDEO: Displays the current video source. When TV,DSS,
DVD, VCR1 or AUX is selected with the function
selector, both AUDIO and VIDEO shows the same
name.
AUDIO: Displays the current analog audio input source.
DIGITAL: Displays the current digital input source.
SURR-MODE: Displays the current Surround mode as follows;
3. MASTER VOLUME CONTROL
Displayed when the MASTER volume is varied or a button of the
remote control unit is pressed.
4. MUTE
When the MUTE button !1/b is pressed, “MUTE ON” will be shown on
screen.
Pressing MUTE button !1/b again will show “MUTE OFF” on screen,
and return to the previous volume level.
AUTO
DTS
DOLBY PL II
MOVIE
6CH STEREO MATRIX STEREO
HALL
STADIUM
DOLBY
PRO LOGIC
DOLBY PL II
MUSIC
MOVIE
6.1CH
SURROUND
VIRTUAL