Denon AVR-1508 - Manual (Page 38)


Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
ENGLISH

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
iPod® Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q Set the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod’s operating instructions.)
w
Assign the Control Dock for iPod’s input.
”System Setup” – ”Input Setup” – ”iPod Assign”
(vpage 23)
2
Either turn <SOURCE SELECT> or press [iPod] to
select the input source assigned in step 1-w above.
R e m o t e i P o d
b If the displays above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
Set [MODE SELECTOR 1] to “AUDIO” and [MODE
SELECTOR 2] to “iPod/NETWORK”.
(vpage 39 “Remote Control Unit Operations”)
Basic Operation
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is “Mode3” (vpage 29).
• Press <ON/STANDBY> and set the AVR-1508’s power to the standby
mode before disconnecting the iPod. Also switch the input source to
one to which “iPod Assign” is not assigned before disconnecting the
iPod.
<SOURCE SELECT> STATUS
op
ui
<ON/STANDBY>
uiop
[1]
[6], [7]
[8], [9]
[2]
[CHANNEL +]
[CHANNEL –]
[ENTER]
STATUS
[MODE
SELECTOR 1]
[MODE
SELECTOR 2]
[Front]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
uiop
[ENTER]
[iPod]
[MODE]
[Rear]
Searching Categories
1
Press o p .
C A T : R o c k
2
Use o p to select the category, then use ui to select
the desired station.
Channel category
• “LOADING” is displayed while stations or data are being received.
• “UPDATING” is displayed while the encording code is being
updated.
• “XM – – –” is displayed if the selected channel cannot be used.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.