Mathey Dearman Maxi Jolli Chain Machine - Manual (Page 12)

11
4.7.12 Twist to release the emergency stop switch.
4.7.13 Light the gas torch per the torch manufacturer’s instructions.
4.7.14 Move the forward / stop / reverse switch to the forward or reverse position.
4.7.15 Slowly move the machine back and forward preheat the pipe to the desired temperature.
4.7.16 Rotate the Maxi Jolli Chain Machine while applying the cutting oxygen to the oxy/ fuel gas torch to
minimize notching of the pipe.
4.7.17 Continue to rotate the chain machine around the pipe until the cut is complete.
4.7.18 Turn off the cutting oxygen valve as soon as the cut is complete per the torch manufacturer’s
instructions.
4.7.20 Depress the emergency stop switch on the motor control box.
4.7.21 Turn of the gas and oxygen to the cutting torch per the torch manufacturer’s instructions.
4.7.22 Move the forward / stop / reverse switch to the center or off position.
4.7.23 Disconnect the motor control box to the 230vac power source.
4.8 - DISASSEMBLY OF THE MANUAL MAXI JOLLI CHAIN MACHINE AFTER USE
4.8.1 Remove the cutting torch from the torch holder (17). Check the functionality of the torch and cutting
tip per the torch manufacturer’s instructions.
4.8.2 Rotate the handle (Figure 3 Item 8E) over center releasing the chain tension.
4.8.3
Disconnect the chain at the chain link (Figure 5 Item 21B) or remove chain coupling bolt (Figure item
21A) and nut (Figure item 21B).
4.8.4 Remove the chain machine base unit from the pipe.
4.8.5 Release both latch handle assemblies (B) and remove the Guide Strip from the pipe if applicable.
4.9 - DISASSEMBLY OF THE 230VAC MOTORIZED MAXI JOLLI CHAIN MACHINE AFTER
USE
4.9.1 Disconnect the motor control box (Figure 5 Item 27) cord to the Right Angle drive motor (Figure 5
Item 22/B).
4.9.2 Remove the cutting torch from the holder (17). Check the function of the gas torch and cutting tip
per the torch manufacturer’s instructions.
4.9.3 Rotate the handle (Figure 3 Item 8E) over center releasing the chain tension.
4.8.4
Disconnect the chain at the chain link (Figure 5 Item 21B) or remove chain coupling bolt (Figure 5
item 21A) and nut (Figure item 21B).
4.8.4 Remove the chain machine base unit from the pipe.
4.8.5 Release both latch handle assemblies (B) and remove the Guide Strip from the pipe if applicable.
5.0 - SAFETY DEVICES
5.1 - Accident Prevention Rules.
The operator should follow all shop, national and manufacturer standard Safety Procedures for the safety of
the operators using the equipment such as:
WARNING: There is a risk of sever electrical shock or death, when
disconnecting the motor control box from the 230vac power source.
WARNING: Grasp the machine firmly when releasing the chain tension,
because the machine will rotate around the pipe causing injury to the
operator.
WARNING: Grasp the machine firmly when releasing the chain tension,
because the machine will rotate around the pipe causing injury to the
operator.