Dish Network DuoDVR 625 - Manual (Page 114)

Page 109
Control Other Devices with the Remote Controls
Scan for Device Codes
If the code for your device is not listed in the tables starting on page 147, use
this procedure to scan the remote control’s memory for the device code.
Instructions Additional Information
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
3. For AUX mode only.
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
• Press 2 for a tuner or
amplifier.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 4.
4. For AUX mode only: Press
the STAR button.
5. Press the blank POWER
button.
This puts your remote in the scan
mode.
6. Press the UP or DOWN
ARROW button repeatedly
until the device turns off.
As you press the UP or DOWN
ARROW button, the remote is
trying each code in the memory to
see if it can turn off your device.
When the device turns off, you have
found a code that might work.
Note: The mode button for the
device will flash rapidly eight times
when you’ve scanned all the codes
for that device.
7. Press the POUND (#) button. This stores the code you found.