Tools of the trade – Directed Audio XTR Amplifier XTR2504 User Manual
Page 14
© 2008 Directed Electronics. All rights reserved.
13
NOTE: Make sure all the equipment in the system is turned off when
making or breaking connections to the input RCA’s or speaker termi-
nals . turn on the system and slowly turn up the volume control only
after double checking all wire connections .
Power for systems with a single amplifier can be supplied by most auto-
motive electrical systems . systems with multiple amplifiers may require
a higher capacity battery, alternator or the use of a storage capacitor .
We strongly recommend the use of a Directed Audio essentials power
capacitor with an extra battery in larger stereo systems .
orion amplifiers generate a certain amount of heat as part of normal
operation . Be sure the area around the amplifier is unobstructed to
allow adequate air circulation . Remember, beach blankets, last week’s
laundry, school books and homework papers located on top of the
amplifier do not improve air flow and may become damaged .
You must first remove the end caps to mount the amplifier (mount-
ing holes are within) . (1) Remove the screws first, (2) lift the end
cap straight up to detach from unit and then (3) pull away from the
amplifier . once mounted replace end caps by following this process
in reverse .
Figure 13
Figura 13
Abbildung 13
1
2
3
Tools of the Trade
Listed below are the majority of the tools required to perform an
installation . Having the proper tools will make the installation that
much easier . some of these tools are necessities; some will just make
the job easier .
Allen Wrenches (2mm and 3mm)
•
DMM or VoM
•
electric drill with assorted drill bits
•
Grommets
•
Heat shrink tubing
•
Marking pen
•
nylon tie straps
•
Phillips and flat blade screw drivers
•
Pliers (standard and needle nose)
•
Reference CD with 1 kHz sine Wave at 0dB level (all bits high)
•
RtA (real time analyzer)
•
soldering iron and solder
•
Utility knife
•
Wire brush or sandpaper for chassis grounding
•
Wire crimper
•
Wire cutters
•
Wire strippers
•