MBM Corporation 307A (PERF & SCORING UNIT) - Manual (Page 16)

15
(6) Place Scoring Block or Perforating Block as desired.
The two Perforation Units, if any, should not touch each other.
(7) Refer [3. How to use]( page 5.)
(3) Remove Lower Transport Roller from the Shaft after loosening Lower Fixing Screw.
(4) Replace with Lower Transport Roller, Blade Receipt Roller, etc. Fix the Phillips screw
at end of the Shaft.
(5) Mount Lower Transport Roller and fix it. Then, re-mount Transportation Shaft to
the Perforation Unit.
Seen as two Perforation Units are mounted.
NOTE ：
Position where perforation can be done is only between the two Lower Transport
Rollers.