Measurement Computing ZonicBook-Medallion rev.5.0 - Manual (Page 13)

Starting the ZonicBook-Medallion
The ZonicBook-Medallion system is ready for use once the tasks in the following checklist have been
completed.
‰ Software Installed (pg. 3)
‰ Channel DIP-switches Set (pg. 5)
‰ Hardware Connected and Powered ON (pg. 6)
‰ Signal Lines Connected to ZonicBook BNC Connectors for Channel Input
‰ Unused BNC Connectors Capped
To start the ZonicBook-Medallion system:
1. On the Start Menu, select Programs.
2. Select ZonicBook-Medallion.
3. Select the applicable software, e.g., eZ-Analyst, eZ-Balance, eZ-TOMAS, etc.
Reference Note: Refer to the applicable document(s) in regard to software specifics.
ZonicBook-Medallion 889596 Getting Started, pg. 7