Measurement Computing PointScan Road Map rev.2.0 - Manual (Page 23)

Select Communications Device
For more information on these settings, click on the <Help> button in the IOToolKit window.
Download the configuration:
Note: You will not be able to download a configuration to a module if you have incorrectly
entered the module’s serial number in the IOToolKit setup screen.
(g) In the Tree View, highlight the “RS-485 connected” module that you are configuring.
(h) Select Operations> Load> Load Now (or click on the Load icon) to download the configuration
to this module. You should get a message that the download has been completed
successfully. If you get a firmware upgrade Error Message “SVCFGRIO,” click <Yes>.
(i) After successful completion of the Download, remove the PointScan/440 module from the base
and replace it with the “RS-485-connected” module previously removed.
Repeat the steps for additional “RS-485 connected” modules:
If applicable, repeat steps “a” through “j” for each additional “RS-485 connected” module.
IOToolKit Screen, A PointScan/204 is Selected
PointScan Road Map 878395 19