Daewoo DT-4280 NH - Manual (Page 56)

57
NOTES:
1) If an external device is not connected or INPUT signal is not
applied, Warning Message (“No Signal”) would be displayed.
2) In this case, check if external device is connected and/or
terminal connection is properly done.
3) Also, you can select input using [INPUT SELECT] button in
the keypad of the PDP unit. The sequence of selection is as
follows:
AV1 --> AV2 --> AV3 --> TV --> PC --> DVI -->
Component1 --> Component2 --> AV1
Component 1
Component1
PC DVI
Component2
AV1 AV2
TV AV3
• “ MULTIMEDIA” button
• “ ” button