MicroE OPS Series - Manual (Page 3)

Page 3
LASER SAFETY INFORMATION: OPS Series
This product is sold solely for use as a component (or replacement) in an electronic product; therefore it is not
required to, and does not comply with, 21 CFR 1040.10 and 1040.11 which pertain to complete laser products. The
manufacturer of the complete system-level electronic product is responsible for complying with 21 CFR 1040.10
and 1040.11 and for providing the user with all necessary safety warnings and information.
MicroE encoders contain an infrared laser diode or diodes. Emitted invisible laser radiation levels have been
measured to be within the CDRH Class 1 range, which is not considered hazardous; however, to minimize
exposure to the diverging beam, the encoder sensor should be installed in its operational configuration in close
proximity to the encoder scale before power is applied.
• Invisible laser radiation; wavelength: 850 nm
• Max power 4.8 mW CW
• CAUTION – The use of optical instruments with this product will increase eye hazard. DO NOT VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS (MICROSCOPES, EYE LOUPES OR MAGNIFIERS).
• All maintenance procedures such as cleaning must be performed with the MicroE encoder turned off.
• Do not insert any reflective surface into the beam path when the encoder is powered.
• Do not attempt to service the MicroE encoder.
INVISIBLE LASER RADIATION
DO NOT VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS
(MICROSCOPES, EYE LOUPES OR
MAGNIFIERS)
Precautions
Follow standard ESD precautions. Turn power off before connecting the sensor. Do
not touch the electrical pins without static protection such as a grounded wrist strap.
Do not touch the tape/glass scale unless you are wearing talc-free gloves or finger
cots. Please read this installation manual for full instructions.
1
2
RoHS OPS models are CE and RoHS compliant.
Manual Version Numbers
OPS-IM Sensor Installation Rev A, issued January 2014
Rev. A1 Changes: updated output frequencies in Appendix A, 01/12/2015
Related Documents
-OPS Data Sheet
-OPS Interface Drawing
-PurePrecision Tape and Glass Scale Installation Manual for OPS