MicroLinks UM02 - user manual User Manual
Page 53
Microscope Application Program http://www.ViTiny.com
53
Copyright © 2008-2012 MicroLinks Technology Corp.
On the other hand, due to the AP will automatically calculate the scale range for
horizontal or vertical scale, thus, the user just need to measure and enter one of
the horizontal or vertical scale. i.e., while only measure and enter the horizontal
scale range, it can calculate the vertical scale range automatically.
Fig.5-51 Fixed ratio adjustment
Set ruler position & show (0,0) position
Ruler can display at Horizontal or Vertical position as per example per below
Fig.5-52 options. The image results in Fig.5-53.
Fig.5-52 Ruler vertical and horizontal
position setting
Fig.5-53 Ruler vertical and horizontal
Display
To set up the horizontal effective range
As shown in Fig. 5-54, there‟re two options for horizontal effective range setup.
The default setting is auto-detection which is able to define the effective display.
If the detected value is “0”, or adjustment required, the manual adjustment
function is also available. There are different unit options, cm and inch, available
in manual adjustment mode.