Delta 36-841 - Manual (Page 9)

9
ASSEMBLING ON/OFF
SWITCH
1. The on/off switch (A) Fig. 10, is shipped attached to a
mounting bracket at the right side of the machine.
2. Loosely assemble switch and switch bracket (A) Fig.
10A, to the inside front lip of the left extension table with
hex flat head screw (D), flat washer (E), and hex nut (F)
through hole (G).
3. Attach the side of switch bracket (A) Fig. 10B, to the
inside of extension table at the front of the saw using the
7/16-20x1-1/4" screw and flat washer (C). Tighten screws
(C) and (D).
Fig. 10
Fig. 10A Fig.10B
A
F
E
D
G
D
C
A
4. Install lock knob (F) Fig. 6B, into threaded end of the
shaft (B). Hand-tighten lock knob at this time. (Do not
over tighten - see “Blade Raising Mechanism”)
Fig. 6B
ASSEMBLING EXTENSION
WINGS
Assemble the extension wings (A) Fig. 7 and Fig. 9, to the
saw table using the six 7/16"-20x 1
1 / 4
" hex head screws
(B) and 7/16" flat washers supplied. Use a straight edge
(C) Fig. 8, to make sure the extension wings (A) are level
with the saw table before tightening the screws (B) Fig. 7
and Fig. 9. NOTE: MAKE SURE FRONT EDGE OF WING
IS FLUSH TO OR SLIGHTLY BEHIND THE FRONT
EDGE OF THE TABLE.
NOTE: When assembling the left extension wing, do
not install the front screw and washer at this time, it
will be installed when assembling the on/off switch.
Fig. 7
A
B
Fig. 8
Fig. 9
A
C
A
B
A
F
B