Mini Tec 130000 MT Flip Front Kit - Manual (Page 4)

4
Step 4: Place hands on flip front end so that you can feel the plastic locks on the back side of the front end
with the tips of your fingers (See Figure 5, and Figure 6). Pull hood straight down to the same position it
was in just before you lifted it in Step 2. During this step, it is important that you don’t let the front end
go backwards towards the car. It could damage the front end and/or the car.
Step 5: Slowly and evenly, push the flip front towards the rear of the car until you can feel the rubber
cups for the plastic locks. Start the plastic locks into the rubber cups, but do not push them in all of the
way, yet.
Step 6: Make sure that both sides of the flip front end are even at the a-panel seem.