MK Products Python LX Torch User Manual

Page 8

Advertising
background image

Python

®

LX Owner's Manual - Page 1

Section A

Installation

Technical Specifications

Wire Capacity

.030" - .045" (0.8mm - 1.2mm) solid hard wire, and cored wire
.030" - 1/16" (0.8mm - 1.6mm) aluminum
Wire Speed

800 IPM (20.3 mpm) max
Duty Cycle - 60%

All ratings are using Argon gas

225 Amps/25 Volts

Air Cooled

450 Amps/25 Volts

Water Cooled

Support Equipment Required

•

C.V. or C.C. power source of sufficient capacity for your needs.

•

Regulated gas supply and hoses.

•

Properly sized power leads from power source to wire feeder and

ground.

•

Water source and hose capable of providing a minimum of

1 quart

(.95 liter) / min. at 45 p.s.i. when using water cooled guns.

Coolant Recommendations

Use Cobra Coolant (Aluminum Protection), P/N 931-0060. Cobra Coolant

does not contain reactive sulphur or chlorine and does not react with copper,

brass or aluminum.
The coolant flow rate should be a minimum of 15 GPH (1 qt/min) between

35 and 45psi. Contact the re-circulator manufacturer for specifications on

pressure.

Gun Lead Connections

Power Cable - Air Cooled

A #2 power cable is used on the Python

LX

gooseneck gun. The gun end of the

cable is stripped to the copper strands and

wrapped with a copper strip. A setscrew

holds the cable securely in the gun body

with torque requirements of 55-60 in-lb.

The cabinet end of the cable is equipped

with a 1/2" ring lug which attaches to the

top hole on the side of the power block.

Supplied with this gun is a 3/8-16x5/8" bolt, a 3/8" spring lock washer and a

5/8" flat washer to attach the ring lug to the power block.

Power Cable - Water Cooled

Python LX water cooled gun utilizes a power/water cable with a #6 AWG

cable inside a 5/16” diameter hose. When water is used with this cable

and the #10 water cooled gas cup (P/N 621-0065), the system is rated at

450 amps @ 60% duty cycle. The gun end is threaded into the gun body.

These connections utilize a conductive sealant and are tightened with torque

requirements of 100 + 5 IN-LB.

Conduit

The Python LX gun comes standard with a poly-lined conduit, for feeding

aluminum wire. The longer fitting with a shallow groove is used on the gun

end. A set screw located on top of the gun handle secures the conduit in

place.

Advertising
This manual is related to the following products: