Monster Ultrathin PowerCard Portable Battery - Manual (Page 6)

5
English SAFETY
Do not leave the product exposed to a heat source or high temperature.
When disposing of the product, take it to a waste electronics service. Batteries
must be recycled or disposed of properly. "Correct Disposal of this product"
marking indicates that product should not be disposed with other household
wastes throughout the EU. To prevent harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product
was purchased. They can take this product for environmental safe recycling.
FCC ID: RJE-178594
This device complies with Part 15 of FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Changes or
modification not expressly approved by the party responsible for Compliance
could void the user’s authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded signal cables. The socket-
outlet shall be installed near the equipment and shall be easily accessible
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s (or your) authority to operate
the equipment. Avoid storage in extreme heat or cold. Avoid exposure to
liquids, temperature extremes and high humidity. The product’s working
temperature range is 0–45°C (32–113°F).
Industry Canada
This device complies with Industry Canada license exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.