Monster HTS 1900G - Manual (Page 24)

16
ENGLISH
HooK-UP GUIDe
Monster GreenPower
™
operation
Please read these instructions before connecting any equipment to the GreenPower RF Controlled (Switched) Outlets .
1 . If you hook up a hard drive-based device such as a DVR, cable/satellite box, or video game console to a GreenPower
switched outlet, make sure that the device is not being read from or written to when you turn off the component
connected to the GreenPower Control outlet .
Important data and settings stored on hard drives (recorded TV shows, game saves, etc .) may be corrupted or deleted 2 .
if power is turned off while the hard drive is being read from or written to . To ensure against the possibility of data
loss or corruption, you should connect hard drive-based devices to unswitched outlets (or disable GreenPower using
the switch located at the end of the PowerCenter .) .
Monster assumes no responsibility for data loss, corruption or damage to hard drive-based devices connected 3 .
to PowerCenters with GreenPower automatic outlet switching .
4 . Some components can take up to 10 minutes to switch to stand-by or sleep mode . If the Monster GreenPower
™
switched
outlets on your PowerCenter do not turn off immediately, please wait approximately 10 minutes to allow the component
plugged into GreenPower Control outlet to switch to stand-by mode . Once this component is in stand-by mode, the
GreenPower switched outlets will turn off, eliminating stand-by energy waste by that component .