Montigo ME34 BV - Manual (Page 6)

Page 6
ME34-BV Homefire
XG0304
Installation
Wiring for the optional Fan Kit
All M34 Series Modular fireplaces may be equipped with optional fan
or blower kits for circulating heat into the living space.
Installations in Canada which employ the fans or blowers must be
electrically grounded in accordance with CSA C22.1 Canadian
Electrical Code Part 1 and/or Local Codes.
Installations in the USA which employ the fans or blowers must be
grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70-1987.
For more information see the Fan Kit Installation Guide included
with the fan kit.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
115/1/60 Supply
G L1 L2
G
L1-WH
L2-BLK
Quick Connect
plug to motor
Figure 7b. Wiring schematic for optional fan kit.
Figure 7a. Wiring for optional air circulating fan kit.
Installing the Log Set
The ME34-BV is supplied with four (4) fibre logs. Logs "A" and "B"
are permanently attached to a fibre base, which is pre-installed by the
factory. To install the two small logs
("C" and "D"), simply place them
onto their mating positions as shown in figure 8a below. When log set is
installed it should look like figure 8b.
Log 'A'
Log 'B'
Log 'C'
Flame Shaper
Figure 8a. Logs 'A' and 'B' shown in factory-installed positions.
Figure 8b. Completed log installation. Logs 'C' and 'D' are placed in
their mating positions, and embers are in place.
Embers Log 'D'
Placing the Embers:
The ME34-DV is supplied with a small bag of embers. Place the ember
material along the middle of the burner between the flame shaper and
log 'A'. Do not let the ember material fall behind the burner tube.
NOTES :
n If logs are not placed properly, excessive sooting will result.
n The surface of the logs will crack due to the heat from the
flames. This is a normal occurance.