Nevion WDM-2-MkII - Manual (Page 6)

WDM-2-Mk2 Rev. A
nevion.com | 6
3 Mounting the CWDM module into frame
The CWDM filter must be mounted in a Flashlink sub rack. This is done from the rear.
Do not use force when inserting the CWDM filter
. The module’s main board has a
special design to utilize both card rails in the FL sub rack. In order to enter the lower
rail before sliding the unit into its final position, please follow the method shown in the
pictures below.
(Please note that the pictures show a not relevant product with similar mechanical
solution).
Figure 2 Enter the module with angle