Q-See QSDT16PCRC - Manual (Page 19)

36 37
CHAPTER 6
RECORDING, PLA
YBACK AND RECORD SEARCH
DELETING RECORDED FILES
While older files will get overwritten by the Recycling Recording function as the hard drive
fills up, you can delete unnecessary or unwanted recordings before then.
PICTURE 6-17
PICTURE 6-18
PICTURE 6-19
PICTURE 6-20
PICTURE 6-21
This function will delete a file or blocks of
files from a specific camera or which were
recorded during a set time.
Select the channel on the left side, and then
the select start date and time and end date
and time of the files you wish to delete.
Click Start to delete files.
You can also remove files manually by
deleting them from the folder where they are
stored, just as with any other PC file.
CAPTURE PICTURES
This feature allows you to capture still images from a recorded event so they can be saved or
printed out.
When the
Search and Playback Interface is displaying only a single channel and the user
hits the Play/Pause button a second time to pause playback, then the video is in Playback
Pause mode.
Snapshot Print setup Print picture
In addition, a second menu will appear below the Search panel. This allows you to make
picture quality adjustments for the present channel, including brightness, contrast, saturation
and hue.
NOTE! This feature is only available in Playback Pause mode on a single
channel.
These changes will not affect the actual
recorded image. Pressing the Default icon
in the lower right of the panel will restore the
original settings.
Make the desired adjustments to the image
and then select the Snapshot icon.
At this time the function buttons above the
File Search panel will be enabled.
Select the number of sequential images you wish to capture and set the save path. The save
path can also be set in the Basic Configuration menu in the
Capture Browse setting. You
can also chose to include which camera took the video and/or the date and time that it was
recorded within the image itself.
Once you have made your selections, pressing the Snap button will save the images. Press
Save to preserve your settings for future use or Exit, if you do not wish to retain the settings.
Pressing the Snapshot button will bring up the Snap window.
The Print Setup button will bring up a
conventional Print Setup window to allow you
to make settings as normal.
Clicking the Print button will open a Print
Preview dialog that includes some extra
features.
Select the Position radio button and adjust
the position of the image on the page using
the + and - buttons.
Selecting the Size radio button will allow you
to adjust the image size using those same +
and - buttons.