Onwa Marine Electronics KR-12X8 - Manual (Page 57)

4. Fasten the cable
5. Connect the lead wires to
in the antenna housing by referring to
the Interconnection Diagram. Fasten the ground washer at the bottom of the
antenna housing as shown in Figure 6-9.
fastening bolts
RD-AP-1568
Figure 6-9 Connection in the antenna housing
Final preparation
1. Place the antenna housing cover on the housing, Loosely fasten the four fixing
bolts on the cover.
Figure 6-10 Fastening the antenna housing cover
2. Apply grease to the two slot pins. Using a wooden hammer to prevent damage
to paint, insert slotted pins into the pinning holes until the pin head is flush
with the scanner housing surface.
Figure 6-11 How to insert slot pins
50