Dynex DX-32E150A11 - Manual

Connecting a DVD or Blu-ray DVD player, cable
box, satellite receiver or game station
Using HDMI (best)
Using component (better)
Note: Cable connectors and jacks are often color-coded. Match the colors when
you connect the AV cable.
Connecting an antenna
Connect a 75 ohm cable (not included) to the ANT/CABLE IN jack on the back of
your TV and the RF OUT jack on the antenna.
Connecting a VCR, camcorder, or game
(good)
Note: Cable connectors and jacks are often color-coded, however this TV is
slightly different. Match the colors of the Audio L/R cables to the red and white
jacks on the TV and the audio source, but connect the video cable (with the
yellow connector) to the green “Y” jack on the TV and to the yellow VIDEO OUT
jack on the video source.
Connecting to a computer
Connecting headphones
Connecting a digital audio amplifier
Connecting power
Connect the power cable to a power outlet.
Setting up your remote control
1 While pressing the release button on the
battery compartment cover on the back
of the remote, lift the cover off the remote.
2 Insert two AAA batteries into the battery
compartment. Make sure that the + and -
symbols on the batteries align with the
+ and – symbols in the battery compartment.
3 Replace the cover.
Front features
Installing the stand
1 Remove the stand, stand column, and screws from the box.
2 Align the holes in the stand with the holes on the stand column, then secure the
stand to the column with the longer screws (M4) provided.
3 Lay a soft, dry, and lint-free cloth on a table and place the TV face down on the
cloth. Insert the stand column into the TV and secure it with the four stand
column screws (M6).
Important: The wide portion of the stand should go towards the front of the TV.
To remove the stand from the TV, perform these steps in reverse order.
Installing a wall-mount bracket
If you want to attach the TV to a wall-mount bracket (not provided), you should first
remove the stand pedestal if it is pre-attached.
To remove the stand column:
1 Lay your TV face down on a table or bench. Make sure that you put down a soft
cushion or cloth so that your TV is not scratched.
2 Remove the four screws holding the stand column to your TV, then remove the
stand and the stand column.
To attach your TV to a wall-mount bracket:
1 Remove the three screws holding the TV to its base, as previously described.
2 Secure the wall-mount bracket to the back of your TV using the fourM6 screws
provided with the bracket.
32" LED-LCD TV
QUICK SETUP GUIDE
DX-32E150A11
Remote control
and
2 AAA batteries
Composite cable
Quick Setup Guide
WE ARE GOING GREEN!
A copy of the manual is not provided in the box
but is available at www.dynexproducts.com
Click Service & Support, enter your model number in
the Product Search field, then click Search.
AC power cord
Remote control
sensor
Power indicator
Volume
+/-
Menu
Channel
+/-
Power button
Input
Side of TV
Power cord
Power outlet
Back of TV
RGB (VGA) cable
Computer
Audio cable (stereo mini plugs)
Back of TV
75-Ohm coaxial cable Antenna, cable TV,
or satellite RF jack
Back of TV
Component video device
Component
video cable
Audio cable
Back of TV
HDMI cable
HDMI device
Side of TV
Back of TV
Optical audio cable
TV stand and 8 screws
(M4 screws: 4, M6 screws: 4)
Composite
cable
Back of camcorder
or game
Back of TV
Back of VCR LINE
OUT
Shorter (M6) screws
THIS SIDE FRONT
Cloth or padding
THIS SIDE FRONT
Narrower portion
of the stand
Wider portion
of the stand
Screws holes
Longer (M4)
screws