Directed Video RVM560 - Manual (Page 12)

12 © 2001 Directed Electronics, Inc.
ASSIGN SOURCE NAMES MENU
NOTE: In this menu use the monitor’s MODE button or the remote’s MENU button to toggle through the available
choices for source names.
SELECTION DESCRIPTION AND OPERATION
SOURCE 1: AV1 Select to change the name of source 1 from the source
names list at the end of this section.
SOURCE 2: AV2 Select to change the name of source 2 from the source
names list at the end of this section.
SOURCE 3: AV3 Select to change the name of source 3 from the source
names list at the end of this section.
WRITE TO SYSTEM ■ Highlight WRITE TO SYSTEM, press the monitor’s
MODE button or the remotes MENU button to
enter the system changes.
■ WRITING TO SYSTEM will be displayed.
■ WRITE SUCCESSFUL - Information entered successfully.
■ WRITE FAILED - Information not entered successfully.
ASSIGN TRIGGER NAMES MENU
NOTE: In this menu use the monitor’s MODE button or the remote’s MENU button to toggle through the available
choices for zone names.
SELECTION DESCRIPTION AND OPERATION
ZONE 1 Select to change the name of zone 1 from the zone names
list at the end of this section.
ZONE 2 Shock sensor - Can not be changed.
ZONE 3 Door switch - Can not be changed.
ZONE 4 Select to change the name of zone 4 from the zone names
list at the end of this section.
ZONE 5 Ignition - Can not be changed.
ZONE 6 Select to change the name of zone 6 from the zone names
list at the end of this section.
ZONE 7 Select to change the name of zone 7 from the zone names
list at the end of this section.