Drolet Hunter Wood Stove - Manual (Page 4)

Assembling your HUNTER :
Fig. 1
LEGS, HEAT SHIELD and FIRE
BAFFLE
1. Turn the stove upside down;
2. Screw the four (4) legs into place (see
fig. 1);
3. Slide the heat shield between the four
(4) legs and the bottom of your stove.
4. Slide the heat baffle into place (inside
the firebox), just below the flue outlet.
Make sure that that the bumps on the
baffle are facing upward.
NOTE : You must slightly bend the sheet
metal in order to get the heat shield into
place. The heat shield’s cross must be
facing upward.
Floor Protection:
Your wood stove has to be placed on a non-combustible surface. The following minimum
specifications must be respected :
NON-COMBUSTIBLE FLOOR PROTECTION
Thickness Front
protrusion
Side
protrusions
Rear
protrusion
1/4" (6 mm) 18" (460 mm) 8" (200 mm) 8" (200 mm)
Clearances from combustible material :
Clearances from combustible material as described below must be scrupulously respected
upon installation.
CLEARANCES FROM COMBUSTIBLE MATERIAL
Back wall Side wall Corners Height *
48" (1220 mm) 48" (1220 mm) 48" (1220 mm) 60" (1524 mm)
* Height, from stove surface to ceiling.
Page 3 of 8