Philco PHWK 2002 - Manual (Page 9)

7 Revison 06/2014 Copyright © 2014, Fast ČR, a. s.
EN
1. Press the keep warm button (3) to activate the function for maintaining a desired water temperature, the
pressed button and the water volume indicator will be lit.
2. The display will show the current water temperature in the kettle together with the water temperature
at the instant that the heating button is pressed.
3. The water temperature will be maintained at the desired level for 30 minutes.
NOTE:
It is not possible to use the keep warm function to lower the temperature of the water in the kettle. If the
ambient temperature is higher than the set temperature, the kettle will not run in this mode.
D. 3-minute boil button (CLEAN WATER function)
1. Press the 3-minute boil button (4) to activate the long boil function, the pressed button and the water
volume indicator will be lit.
2. The kettle will bring the water to a boil and boil it for 3 minutes.
3. The long boil function reduces the chlorine level in the water and ensures the cleanness of the beverage.
4. Before boiling water again, leave the kettle off for 15-30 seconds.
E. Heat water to a desired temperature after a boil
The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.
1.
Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Confi rm by pressing the quick boil button (1).
3. The kettle will bring the water to a boil and as soon as it cools to the preset temperature, a short sound will
be made.
NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the
water in the kettle. If you set the target water temperature lower than the ambient temperature, the kettle
will not run in this mode.
F. Heat water to a desired temperature and maintain that temperature
The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.
1.
Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Press the keep warm button (3).
3. Water will heat up to the desired temperature at which is will be maintained for 30 minutes.
NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the
water in the kettle. If you pour room temperature water at 25 °C into the kettle and set the target water
temperature to 20 °C, the kettle will not run in this mode.
G. Heat water to a desired temperature after a preceding boil and maintain that temperature
The target temperature can be set to 20, 30, 40, 50, 60, 70, 80 or 90 °C.
1.
Repeatedly press the set temperature button (2) to set the desired water temperature.
2. Press the keep warm button (3).
3. Press the quick boil button (1).
4. As soon as the water in the kettle reaches the boiling point, the temperature will start to gradually fall. After
reaching the set temperature, the water in the kettle will be maintained at this temperature for 30 minutes.
NOTE:
It is not possible to use the heat water to desired temperature function to lower the temperature of the water
in the kettle. If you set the target temperature to a lower level than the ambient temperature, the kettle will
not run in this mode.