Posiflex JIVA XT-2614E User Manual
Page 2
Hardware Installation
Installation and Configuration of XT-
2614E
During Installation and configuration of XT-2614E,
please do NOT power ON your monitor and
terminal.
Start to install XT-2614E according to the following steps.
1.
Find the DC IN jack on the I/O plate. Upon
connecting the included power adaptor to
the jack, XT-2614E will power up after a
while.
2.
After powering up for around 50~70
seconds, the operation screen is ready for
use.
3.
On the rear left side of the main unit, there
are brightness adjustment push buttons.
Each single press continually on the + or –
brightness button changes the LCD panel
display brightness slightly.
4.
On the lower left corner of task bar, press
Sound +/- buttons to increase/decrease
volumes, or scroll up/down the volume bar.
2