Posiflex PD-2609UE - Manual (Page 12)

UTC Emulation Mode
Command Syntax: Hexadecimal Code
Mode Name Hex Code Function Description
UTC PASS
THRU
MODE <ESC>uA$<CR> 1B 75 41 $ 0D Top Line message
<ESC>uA<CR><ESC>
uB<CR> 1B 75 41 0D
1B 75 42 0D Clear Display
<ESC>uB $<C 1B 75 42 $ Bottom line message
<ESC>uD $< 1B 75 44 Top line continuous
scrolling
<ESC>uE $ 1B 75 45 Set/Display time
<ESC>uF $ 1B 75 46 Top line 1 time scroll
<ESC>uH $ 1B 75 48 Redefine graphic
<ESC>uIx<CR> 1B 75 49 x 0D Display fonts
<ESC>utcEx 1B 75 74 63 45 x Change d mode
<ESC>utcFx 1B 75 74 63 46 x Change RS mode
<ESC><RS>* 1B 1E* Direct to pole mode
DIRECT TO
POLE MODE <EOT>x 04 x Brightness
<BS> 08 Back spacing
<HT> 09 Horizontal tab
<LF> 0A Line feed
<CR> 0D Carriage return
<DLE> 10 Display position
<DC1> 11 Normal display mode
<DC2> 12 Vertical Scroll mode
<DC3> 13 Cursor on
<DC4> 14 Cursor off
<CAN> 18 Clear to end of line
<EM> 19 Clear to end of
display
<SUB>x 1A x Display fonts
<ESC>d* 1B 64* Pass thru mode
<FS> 1C Flashing text start
<GS> 1D Flashing text end
<RS> 1E Clear display
<US> 1F Reset display
Notes:
 The “Mode” column specifies the specific mode applied to the commands.
Two modes are available: “P”(UTC pass thru mode) and “D”(Direct to
pole mode).
 The code marked with an asterisk (*) means that the code can be changed
by other command.
 The letter “x” represents a variable of which the length is 1 byte.
12