Dish Network 5.4 - Manual (Page 19)

9
R EADING O UT THE R EMOTE C ONTROL C ODES
These instructions explain how to check the codes you put in the
remote control when you set it up. Be sure to write them in the spaces
provided on the inside of the back cover.
Instructions Additional Information
1 Press and hold the mode
button for the equipment
you want the remote to
control. When all the other
mode buttons light up, let
go of the mode button—
that mode button should
now be flashing.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, the TV mode light
flashes.
2 Press the POUND (#)
button twice. The mode
button flashes the number
for each digit of the
equipment code, with a
pause between the groups
of flashes. A quick flash is
for zero.
For example, if the code is 570,
the mode button flashes five
times, pauses, flashes seven
times, pauses, and quick flashes
for zero.
For AUX mode, the first
group of flashes tells you
what type of device the
AUX mode controls. A
quick flash (zero) before
the three-digit code is for a
TV; one regular flash is for
a VCR or DVD player; and
two flashes is for a tuner or
amplifier. For example, if the TV code is
570, the AUX mode button
flashes once quickly, pauses,
flashes five times, pauses,
flashes seven times, pauses, and
quick flashes for zero.
For a satellite receiver
programmed in AUX mode,
the group of flashes tells
you the address number. For example, if the AUX mode
button is set to control a
satellite receiver with address 5,
the AUX mode button flashes
five times.