REMKO MKT 240 - Manual (Page 2)

MKT 240
Recessed grip
Control
panel
Infrared
receiver
rollers
plate fi ns
2
Before delivery, this device was sub-
jected to numerous material, function,
and quality tests. Nevertheless, the
device may present a danger if used by
untrained personnel, improperly, or not
according to regulation!
Observe the following notices:
■ The device is not suited for out-
door operation.
■ The device may not be set up and
operated in rooms at risk of explo-
sion and in atmospheres containing
oil, sulphur, or salt.
■ Make sure it is at a suffi cient
security distance to infl ammable
objects.
■ Do not place any objects on the
device.
■ Observe the minimum clearances
(Fig. 2).
■ Do not insert any objects into air
inlets and outlets.
■ Erect the device on an even, stable
surface. Never place it on its side
(Fig. 3).
■ Operate the device only when it is
upright.
■ Do not expose the device to direct
water spray.
■ Operate the device only within its
permissible operating limits (16 to
35°C).
■ Do not pull on or bend the mains
supply line.
■ Protect all electrical lines of the
device from damage, even from
animals.
■ Select the extension lines of the
mains supply line depending on
the connected load of the device,
the line length, and the intended
use.
■ Do not lay lines under carpeting.
■ Never operate the device with-
out an air fi lter.
■ Never direct the air fl ow at
people.
■ Never open the device housing
as there is a danger of an electri-
cal shock.
■ Work on the cooling system and
the electrical equipment may be
carried out only by an
authorised specialist.
Transporting the device
■ Before transport, switch off the
device and pull the mains plug.
■ Transport the device only in an
upright position.
■ We recommended that any
condensate be drained using the
condensate drain spout on the
back side of the device before
transport.
■ After every transport of the
device, wait at least 5 minutes
before recommissioning it
(Fig. 4).
Safety Notices
Operation other than as de-
scribed in these instructions is
prohibited. Nonobservance leads
to the extinguishment of any li-
ability and warranty claims.
Fig. 2
Minimum clearances
Side
500 mm
Front 500 mm
Rear
400 mm
Top 100 mm
Scope of Supply
1 MKT 240 air conditioner
1 Infrared remote control
2 Batteries (type AAA/1.5 V)
1 Air outlet hose with connection
pipe adapter and win
dow jet
with plug
Window
jet
Fig. 1 MKT 240
Caution
TIP
CAUTION
DANGER