Local codes, Unpacking, Safety information – Desa CDL3924PT User Manual

Page 4

Advertising
background image

www.desatech.com

111347-01E

4

SAFETY INFORMATION

Continued

3. If you smell gas

• shut off gas supply

• do not try to light any appliance

• do not touch any electrical switch; do not

use any phone in your building

• immediately call your gas supplier from

a neighborʼs phone. Follow the gas

supplierʼs instructions

• if you cannot reach your gas supplier, call

the fire department

4. This heater shall not be installed in a bedroom

or bathroom, unless installed as a vented appli-

ance. See Installing Damper Clamp Accessory

for Vented Operation, page 11.

5. Before installing in a solid fuel burning fireplace,

the chimney flue and firebox must be cleaned

of soot, creosote, ashes and loose paint by a

qualified chimney cleaner. Creosote will ignite if

highly heated. Inspect chimney flue for damage.

If damaged, repair flue before operating heater.

6. Do not burn solid-fuel in a masonry or UL127

factory-built fireplace in which a vent-free

room heater is installed.

7. If fireplace has glass doors, never operate this

heater with glass doors closed. If you operate

heater with doors closed, heat buildup inside

fireplace will cause glass to burst. Make sure there

are no obstructions across opening of fireplace.

8. To prevent the creation of soot, follow the instruc-

tions in Cleaning and Maintenance, page 21.

9. Before using furniture polish, wax, carpet

cleaner or similar products, turn heater off. If

heated, the vapors from these products may

create a white powder residue within burner

box or on adjacent walls and furniture.

10. This heater needs fresh, outside air ventilation

to run properly. This heater has an Oxygen

Depletion Sensing (ODS) safety shutoff sys-

tem. The ODS shuts down the heater if enough

fresh air is not available. See Air for Combus-

tion and Ventilation, page 5. If heater keeps

shutting off, see Troubleshooting, page 22.

11. Do not run heater

• where flammable liquids or vapors are

used or stored

• under dusty conditions

12. Do not use this heater to cook food or burn

paper or other objects.

13. Do not use heater if any part has been exposed

to or under water. Immediately call a qualified

service technician to inspect the room heater

and to replace any part of the control system and

any gas control which has been under water.

14. Do not operate heater if any log is broken. Do

not operate heater if a log is chipped (dime-

sized or larger).

15. Turn heater off and let cool before servicing,

installing or repairing. Only a qualified service

person should install, service or repair heater.

16. Operating heater above elevations of 4,500

feet may cause pilot outage.

17. To prevent performance problems, do not

use propane/LP fuel tank of less than 100 lb.

capacity (propane/LP units only).

18. Provide adequate clearances around air

openings.

LOCAL CODES

Install and use heater with care. Follow all local

codes. In the absence of local codes, use the lat-

est edition of the National Fuel Gas Code ANSI

Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note:

Where listed vented decorative logs are

required, thermostat operation is not permitted.

State of Massachusetts: The installa-

tion must be made by a licensed plumber

or gas fitter in the Commonwealth of

Massachusetts.
Sellers of unvented propane or natural

gas-fired supplemental room heaters shall

provide to each purchaser a copy of 527

CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for

bedroom and bathroom installation in the

Commonwealth of Massachusetts.

UNPACKING

CAUTION: Do not remove the

data plates from the grate as-

sembly. The data plates contain

important warranty and safety

information.

1. Remove logs and heater base assembly from

carton. Note: Do not pick up heater base as-

sembly by burners. This could damage heater.

Always handle base assembly by grate.

2. Remove all protective packaging applied to

logs and heater for shipment.

3. Check all items for any shipping damage. If

damaged, promptly inform dealer where you

bought heater.

Advertising
This manual is related to the following products: